Multiple Lumen Center Venous Catheter Production Line Factory Directly

Multiple Lumen Center Venous Catheter Production Line Factory Directly 

Application of catheter:

Center venous catheter belongs to the intravascular tube,placed in the vena cava, can be used for measuring central venous pressure, intravenous infusion, blood dialysis, tumor chemotherapy and establish a good infusion channel etc. Material are Silica gel or plastic PU.

Production specifications:

Single cavity(14G 16G 18G 20G)/double cavity（4F 5F 7F 8F 8.5F 11.5F 12F)/three cavity（5.5F 12F) /four cavity（8.5F) etc. According to different products section form and size, extrusion line is equipped with different extrusion die.

The composition of this machine:

about machine:

Medical Center Venous Catheter Extrusion Line  is mainly used in the production of ordinary catheter and spring anesthesia catheter and precision medical level of various types, such as reinforced endotracheal intubation catheter, combining with the production equipment and production technology of Mr, catheter has good elasticity, high tensile strength, not easy to fold, the medicine even wait for a characteristic, is the production of multicolor, porous or multilayer precision medical catheter manufacturers the ideal equipment.

Medical anesthesia tube refers to as the disposable anesthesia epidural catheter, catheter use PVC material manufacturing, tube joint use ABS materials manufacturing, product composited by tube and tube joint, mainly applied in clinical surgery epidural anesthesia, and for the patient transfer anesthesia and analgesia liquid medicine.

The special application of anesthesia catheter makes the tube size precision requirements are extremely accurate, usually the allowable tolerance should not more than +/- 0.02 mm.

Machine features:

1. The extruder adopts Siemens man-machine interface and computer control operation system, maintenance-face motor from Germany and driving by decelerator, which can effectively avoid low efficiency and big transmission error of general belt transmission, dust, grease dirt and noise produced during manufacturer process are also avoided.

2. The extruder and haul-off unit adopts complete closed loop servo motor which enables hualing speed to change with the extruder speed, and consequently ensure the speed synchronization on the whole line with high precision and frequency responsibility. It can also prevent pipe diameter from flucuating when working speed is changed due to environmental factors, and thus ensures product precision up to ±0.02mm.

3. The cooling tank is made of SUS304 stainless steel with glass closed structure and the stainless steel centrifugal pump for the special medical grade deionizer water, and the water annulus and low vacuum molding ensures fine roundness and precision of the pipes, the air annulus drying device allows the cooling water to be used circularly and not to splash on the ground.

4. The haul-off unit consists of belt made from Switzerland, servo motor and the controller of Japan Mitsubishi, turbine and worm decelerator from Germany, it can work with high precision and stability and no skidding or noise.

5. The cutting machine is equipped with aluminum alloy rotatable knife arm of low inertia as well as special cutting knife pouch which ensures smooth cuts, it’s servo motor driving and PLC of Japan Mitsubishi as well as Siemens man-interface ensure precision of the cutting length, and the cutting length and cutting times can be set and counted by automatically.